In general, holding the connector in your hand, tab side down, open end towards you, and insert the stripped cable with the *blue* wire on the left, except for RJ11 4-wire connectors, which has *yellow* on the left. When crimping RJ ends onto the cables, the following colors are assigned to the following pins on the connector (see above): This is a serial connection RS232 Null modem data wiring configuration with Full Handshake capability and hardware flow control, DTE devices.ĭata cables are straight through for DCE devices. Pin number and strand color for 10 base T 1 (ie, to connect two systems to each other.) This allows back-to-back twisted pair tranceivers to work. ![]() Null Ethernet, using standard RJ ethernet cable. In an RJ45 to DB-style connector, the pins correspond to the following colors: Pin number and strand color for 10 base T This is the wiring for an RJ45 ethernet cable on a 10 base T wiring system. Hopefully this will help get the equipment connected.īelow some of the signal abbreviations are defined: This is a collection of pinouts that I've gathered over the years. Mini-DIN-8 (Indigo, Indy, Indigo2, PI ).DB-9 Male (O2, Octane, Origin, MIPS, IBM-PC). ![]() DB-9 Female (Challenge, Onyx, PI, Power Series).Last modified: Mon Aug 06 16:34: Table of Contents:
0 Comments
Leave a Reply. |